Shenzhen PM-9000 Express Manuel de l'opérateur télécharger pdf (Page 149)

•

BEAT VOL

Beat volume

Range: 0-10. 0 indicates disabled and 10 indicates the

maximum volume.

•

PACE ON: When ON is selected, a detected pacemaker signal is

indicated by a "|" symbol above the ECG waveform.

OFF: When OFF is selected, the pacemaker analysis is

disabled.

NOTE

•

When monitoring a patient with a pacemaker, PACE must be turned ON.

Otherwise, the system will count the pacemaker pulse as QRS complex. Do not

completely depend on the alarms of heart rate. The patient with a pacemaker must

be nearly monitored.

•

When PACE is turned ON, the system will neither detect the arrhythmia relating

to premature ventricular beats (including PVCs counting) nor perform the ST

analysis. When monitoring a patient without a pacemaker, PACE should be

turned OFF.

•

The PACE tag can be printed in the real-time recording when PACE is turned

ON.

•

NOTCH

Determines whether filter or not.

ON: The monitor protects the signals from the noise

generated by the power line.

OFF: No filtering.

NOTE

•

If the filter method of the ECG waveform is set to a non-diagnostic mode, only the

NOTCH option ON is active and the monitor filters the signals of the power line

frequency; if the filter method is set to the diagnostic mode, two NOTCH options,

both ON and OFF, are active, and the system sets the NOTCH to OFF

automatically.

11-12

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 338 339

Shenzhen PM-9000 Express Manuel de l'opérateur Page 149